How to Relight a Water-Heater Pilot Light

If you woke up to a cold shower, there's a good chance the pilot light on your water heater has gone out. Learn how to turn it back on and you'll be known around your house as the keeper of the flame.

You will need

  • Gas-powered water heater
  • Lighter or matches
  • Flashlight (optional)

Step 1 Turn heat to LOW Turn the temperature knob on the outside of the unit to the lowest setting.

Step 2 Remove front panels Find the metal access panel under the knobs near the bottom of the heater and remove it. Also remove the inner heat shield panel.

Step 3 Turn to OFF Turn the gas control knob to the off position and wait a minute for any leftover gas to clear the line. Blow gently through the access door to disperse any remaining gas vapors.

Step 4 Turn to PILOT and light Now turn the control to the pilot setting, and hold a lit match or lighter in the opening near the end of the metal pilot supply tube.

Step 5 Hold for 60 seconds Press and hold the reset or pilot button on the control box until the pilot lights, and continue to hold it for 60 seconds after the pilot is lit.

Step 6 Turn to ON After 60 seconds, turn the control knob to the on position.

Step 7 Repeat if necessary Repeat the process once if the pilot did not light the first time.

Step 8 Set temperature Replace the access panels on the heater and set the temperature knob to the desired setting. Wait a while for the tank to heat up and you’re back in business.